So use the Service Tool released in 2016. To find the compatibility of a printer with the Service Tool, one way is to know the year the printer was released, and the year the Service Tool was released.Ĭanon MG2550S was released in July 2016 (if I'm not mistaken). The Service Tool is the same as other applications in that there are updates for each version.
Each Service Tool supports several types of printers. Every time a new printer series is released, Canon will release a new Service Tool. It seems that ST.4906 doesn't support MG2550S.Ībout the Service Tool (the information below is only my personal opinion) If ST.4906 is not suitable for MG2550s, another alternative solution is to replace the printer's EEPROM IC. If pressing the STOP button 5 times fails, repeat the procedure, and press the STOP button 6 times. To enter Service Mode, press the STOP button 5 times. The link for ST.4906 is in a post entitled "Canon Pixma iP110 error code. In this blog, I am sharing a Service Tool that you might try ST.4906. Then if the Service Tool is newer, it can reset the MG2550s. Unfortunately there is no ST.3900 on the internet. In my opinion, a suitable Service Tool for the MG2550s is likely the ST.3900.
HOW TO RESET CANON MX320 PRINTER MANUAL
In the Service Manual document for Canon MG2400 series and MG2500 series (QY8-2349-000), there is no mention of Service Tool that supports Canon MG2500 series.
HOW TO RESET CANON MX320 PRINTER CODE
You have tried Service Tool v1050, v1074 and v3400, and you see error code 006 (006 means the Service Tool does not support the printer). For Canon MG2550s, reset is done with the Service Tool. Reset can be done in two ways: reset manually (as in this post), and reset with the Service Tool. When I plug in it again the printer start but it give me again the INK Waste absorber error. When I put printer on Service Mode if I press again Resume button just green ON LED stay on and if I try to push 2 or 4 times and next I press ON/OFF button ON Led blinks and next printer shut off and its impossible to power ON again if I dont' disconnect the power cord. Right now I tried Service Tool v1050, v1074 and v3400. I think its right because if next to it I run Service Tool buttons are working and not grayed, but everything I try to push on program I get back error 06. This one is an AIO printers with scanner so (as written here) to enter in "Service Mode" should be doing keeping pressed Resume then ON/OFF button and next release Resume and press it 6 times and next release both buttons but in this way ON led is green but printer is offline and nothing happen if I press again Resume no matter how much times.įinally I found that this model need 4 times Resume pushes to Enter into Service Mode.
0 kommentar(er)
